4. Unscrew the bubble of the camera.
5. (Optional) Insert the memory card to the camera, if your camera
supports memory card installation. Refer to Section 2.1.
6. Route the cables and fix the camera to the incline mounting
bracket with three supplied self-tapping screws.
Note:
If you install the camera in outdoor, install the water-proof jacket
to the network cable. See Section 2.4
Fix the Camera to Wall Mounting Bracket
7. Adjust surveillance angle of camera. Refer to Step 4 in Section
2.2.
8. Install the bubble back to the camera.
To Next Page
Loading...