AEE sd20 - Page 19

-16-
standby process, SD20 will be waked up. The default
standby time is 5 minutes when selecting to restore the
factory default;
e.TV output format: NTSC or PAL; the video format
outputted to TV can be selected. If the selected format is
changed, please unplug the AV cable and then reinsert it
to update the parameters;
f.Format: After confirming that all files recorded are not
needed to be saved, all files can be removed by
formatting.
Note:If there is no card inserted, the memory of the
machine will be formatted; after inserting card, the system
will format the card inserted, but not format the memory
of the machine;
g.Factory default: The operation restores the parameter
settings to factory default. After restoring, the system
will set the display mode of submenu of the “ Menu” in
English state. Press “M” key to enter the menu selection,
press “<” or “>” key to enter the menu “Setup”, press “-“ key
to select the option “ Language” , and then it can set in
Chinese state. The system will set the time at 2011.01.01
after restoring factory default;
h.Language: “English”, “Simplified Chinese” or “Traditional
Chinese” can be selected via left or right key;
I. Light source frequency: Select the light source frequency
50Hz or 60Hz, depending on local grid frequency, in
order to avoid the screen flickering in preview mode or in
video recording;
j. Date/Time: Time can be adjusted and changed. It will be
displayed on the bottom right corner of the video file or
photo file when recording or shooting;
Note: To press “M” key under the submenu may exit from it;