32
“Orientation” menu
This setting allows you to install the
camera inverted and still see the image
correctly.
1. Select the respective camera (cam-
era 1 or camera 2).
2. Press the “Enter” button (12) to
invert the image.
“Setup” menu
Pairing
This menu is used to pair the camera
with the monitor. The device can be
connected to two cameras.
1. Select the camera you want to pair
(“PAIR1” for camera 1 or “PAIR 2” for
camera 2).
2. Hold the pairing button (2) with
the included pairing pin (14) or a
paper-clip until the pairing has been
the camera image.
Time-Out
long the camera image will be displayed
after pressing the “Standby” button.
30 sec.
45 sec.
60 sec.
Information about use
You may have to turn the ignition
to activate the vehicle’s 12 V socket.
Please refer to the owner’s manual
for your vehicle. Contact a specialised
shop if you are unsure.
Do not cover the device during use
and ensure proper ventilation.
Switching the monitor on/o
1. Press the “Standby” button (9) to
activate the screen.
2.
the screen.
Operating the monitor
1. Press the “Menu” button (10) to
open the menu.
2. Use the “Up” (11) and “Down” (13)
buttons to select a symbol or set-
ting.
3. Press the “Enter” button (12) to con-
4. Press the “Menu” button (10) to go
back or exit the menu.
“Screen settings” menu
1. Select the respective camera (cam-
era 1 or camera 2).
2. Select a setting:
Brightness
Contrast
Colour
To Next Page
Loading...