AEG A18F10FN - Page 18

18
18
BATTERY AND CHARGER
Compatible battery pack
(not included)
Compatible charger
(not included)
L1820R
L1820S
A18FB2
L1825R
L1830R-X5
L1840R
A18B4
A18FB4
L1850R
A18FB5
L1860R
L1860R-X5
L1890R
AL18G
BL1218
BLK1218
BL18DPS
BL18S
Use AEG 18V battery and charger only
Read all safety warnings, instructions, illustrations and
specifications provided with this power tool. Failure to follow
all instructions listed below may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future reference.
NAILER SAFETY WARNINGS
Always assume that the tool contains fasteners. Careless handling
of the nailer can result in unexpected firing of fasteners and personal
injury.
Do not point the tool towards yourself or anyone nearby.
Unexpected triggering will discharge the fastener causing an injury.
Do not actuate the tool unless the tool is placed firmly against
the workpiece. If the tool is not in contact with the workpiece, the
fastener may be deflected away from your target.
Disconnect the tool from the power source when the fastener
jams in the tool. While removing a jammed fastener, the nailer may
be accidentally activated if it is plugged in.
Use caution while removing a jammed fastener. The mechanism
may be under compression and the fastener may be forcefully
discharged while attempting to free a jammed condition.
When fastening electrical cables, make sure the cables are not
energized. Hold the tacker only by insulated gripping surfaces.
TECHNICAL DATA NAILER
A18F10FN / A18F10FNNZ
Rated voltage 18 V
Fastener type 30-34˚ D-Head Hard Paper Strip Framing nails (Clipped Head)
Diameter 2.9 to 3.3 mm
Length min./max 50/90 mm
Recommended Cycle rate 500/hr
Burst cycle rate (A18F10FN) – bump fire mode 3 / second
Burst cycle rate (A18F10FNNZ) 2 / second
Magazine capacity 67 nails (3.06 mm diameter)
Fastener range 50 to 90 mm
Weight - not including battery pack 4.2 kg
Noise/vibration information
Measured values determined according to EN 60 745.
Typically, the A-weighted noise levels of the tool are:
Sound power level (K = 3 dB(A)) L
pA
= 95.5 dB (A)
Sound pressure level (K = 3 dB (A)) L
wA
= 106.5 dB (A)
Wear ear protectors!
Total vibration values (vector sum in the three axes) determined according to EN 60745.
Vibration emission value a
h
= 12.2 m/s
2
Uncertainty K 1.5 m/s
2
WARNING
The declared vibration total values and the declared noise emission values given in this instruction manual have been measured in accordance
with a standardised test and may be used to compare one tool with another. They may be used for a preliminary assessment of exposure.
The declared vibration and noise emission values represent the main applications of the tool. However, if the tool is used for dierent applications,
used with dierent accessories, or poorly maintained, the vibration and noise emission may dier. These conditions may significantly increase
the exposure levels over the total working period.
An estimation of the level of exposure to vibration and noise should take into account the times when the tool is turned o or when it is running
idle. These conditions may significantly reduce the exposure level over the total working period.
Identify additional safety measures to protect the operator from the eects of vibration and noise, such as maintaining the tool and the
accessories, keeping the hands warm (in case of vibration), and organising work patterns.