AEG CFN90 - User Manual

Questions and Answers

I
iwolfAug 4, 2025
Why does my AEG Nail Gun tool jam frequently?
- S
  Stephanie HamiltonAug 4, 2025
  Your AEG Nail Gun may be jamming frequently due to several reasons. It could be that the fasteners are the incorrect size or are damaged, so verify the fastener size and replace any damaged fasteners. Also, check for loose magazine or nose screws and tighten them if necessary. A dirty magazine can also cause jams, so clean it thoroughly. Finally, a worn or damaged driver might be the culprit, requiring you to install a driver maintenance kit.
B
beth02Aug 12, 2025
What to do if my AEG CFN90 operates sluggishly?
- C
  Christine HarrisAug 12, 2025
  If your AEG Nail Gun is operating sluggishly, there are a few potential causes. First, verify that the air supply is adequate. Inadequate lubrication can also cause this issue, so lubricate the tool. Finally, inspect for worn or damaged O-rings or the bumper, and if found, install an overhaul kit.
R
rodriguezericAug 20, 2025
How to fix an air leak near the bottom of my AEG CFN90 Nail Gun?
- S
  Sara WarrenAug 20, 2025
  If you notice an air leak near the bottom of your AEG Nail Gun, it could be due to loose screws. Make sure to tighten them. Another possible cause is worn or damaged O-rings or the bumper, in which case you should install an overhaul kit.
B
Brandon MorrisAug 27, 2025
What to do if there's an air leak near the top of my AEG Nail Gun?
- R
  Rebecca RamseyAug 27, 2025
  If you're experiencing an air leak near the top of your AEG Nail Gun or in the trigger area, it may be due to loose screws, so try tightening them. Alternatively, worn or damaged O-rings or seals could be the cause. If that's the case, install an overhaul kit.