10
TROUBLESHOOTING
PROBLEM CAUSE
POSSIBLE SOLUTION
Air leak near the top of the tool
or in the trigger area
Loose screws Tighten screws
Worn or damaged O-rings or seals Install overhaul kit
Air leak near the bottom of the
tool
Loose screws Tighten screws
Worn or damaged O-rings or bumper Install overhaul kit
Tool does nothing or operates
sluggishly
Inadequate air supply Verify adequate air supply
Inadequate lubrication Lubricate the tool
Worn or damaged O-rings or bumper Install overhaul kit
Tool jams frequently Incorrect fasteners Verify that fasteners are the correct size
Damaged fasteners Replace fasteners
Loose magazine or nose screws Tighten screws
Dirty magazine Clean magazine
Worn or damaged driver Install driver maintenance kit
TPG20110208v4
To Next Page
Loading...
