12 818 22 13-00/2
Reversing the door
The door hinges can be changed from right (as supplied) to left if
required to suit the location where the appliance is installed.
1
Warning! Unplug from the mains before reversing the door.
Open the door and remove the
plinth cover to the front. Move
the door hinge bracket cover on
the plinth cover from the left to
the right. Close the door.
0 1. With the door closed, remove the
cross-head screws from the lower
door hinge bracket and remove
the door hinge bracket down-
wards.
2. Remove the door fitting from the
door hinge bracket (1, 2). Move
the hinge bracket pivot from the
right to the left hand hole (3).
Place the door fitting supplied on
the hinge bracket pivot (4, 5).
1
2
5
4
3
To Next Page
Loading...
