www.aeg.com 9
TROUBLESHOOTING
When fault indicators show that the system is not operating properly, perform the following check.
Commonly Asked Questions & Topics
Carry out the operations below for commonly-occurring questions or faults.
Questions or Faults Possible Diagnosis Corrective Steps / Reasoning
Can the lters be washed?
NO
Replace the compound lter instead
of wash, the pre-lter can be wiped.
The control panel does
not seem to work.
• Power cord issue
• Filter compartment issue
• Fan Motor Failure
1. Please ensure power cord is rmly
attached to the unit as well as socket
on the wall and then retry pressing the
ON/OFF icon.
2. Please reopen bottom of the unit,
readjust the lter so it is centrally placed
in cavity and close the bottom. Ensure
bottom is rmly in place & locked and
then retry operating the unit.
3. If above two steps do not resolve this
issue, then the unit has experienced a
fan motor failure and will not operate.
Please contact AEG authorized servicer
for further troubleshooting or repairs.
The equipment emits a lot
of noise.
The installation location is not
at even level or the lter is not
properly inserted.
Install the equipment on a level
surface and re-conrm lter
installation position and order.
The equipment operates
normally but the outgoing
air volume is signicantly
reduced.
The outlet might be blocked by
a foreign object or the lter has
not been replaced in a timely
manner.
Please re-adjust the equipment
installation position to ensure enough
space is reserved, and confirm that
filter have been replaced according to
filter replacement indicator status.
If the fault encountered is not listed above, please call the Customer Service Hotline.
To Next Page
Loading...
