To activate the outer ring: turn the knob
clockwise through a light resistance to .
Then turn the knob counterclockwise to the
correct heat setting.
To deactivate the outer ring: turn the knob
to the off position. The indicator goes out.
6.3 Residual heat indicator
WARNING!
As long as the indicator is visible, there is
a risk of burns from residual heat.
The indicator appears when a cooking zone
is hot, but it does not function if mains power
is disconnected.
The indicator may also appear:
• for the neighbouring cooking zones even if
you are not using them,
• when hot cookware is placed on cold
cooking zone,
• when the hob is deactivated but the
cooking zone is still hot.
The indicator disappears when the cooking
zone has cooled down.
7. HOB - HINTS AND TIPS
WARNING!
Refer to Safety chapters.
7.1 Cookware
The cooking results depend on the cookware
material
• recommended: aluminium, copper
• not recommended:stainless steel, cast
iron, glass
The bottom of the cookware must be as
thick and flat as possible.
Ensure pan bases are clean and dry
before placing on the hob surface.
Do not use cookware on the ceramic hob
with bases with pronounced edges or
ridges, e.g. cast iron pans. These could
scratch or scour the hob surface
permanently.
Cookware made of enamelled steel and
with aluminium or copper bottoms can
cause a colour change on the glass-
ceramic surface.
To save energy and ensure that the hob
operates properly the cookware bottom must
have a suitable minimum diameter.
7.2 Minimum cookware diameter
Cooking
zone
Cookware diam‐
eter (mm)
Power (W)
Left rear 125 - 145 1200
Right rear 150 - 180 1800
Right front 150 - 180 1800
Left front 140 - 210 1000/2200
7.3 Simplified cooking guide
The data in the table is for guidance only.
ENGLISH 11
To Next Page
Loading...
