49
What to do if …
If you are unable to remedy the problem by following the above
suggestions, please contact your dealer or the Customer Care De-
partment.
Problem Possible cause Remedy
The oven does not heat up The oven has not been
switched on
Switch on the oven
The clock has not been set
to the current time
Set the clock to the cur-
rent time
The required settings have
not been set
Check the settings
The ovenís safety cut-out
has been triggered
See Oven Safety Cut-out
The house wiring fuse (in
the fuse box) has tripped
Check fuse If the fuses trip
several times, please call a
qualified electrician
The oven lighting is not op-
erating
The oven light bulb is
faulty
Replace oven bulb
The pyrolysis function is
not working (“C1“ is shown
in the time display)
The oven shelf runner has
not been removed.
Remove oven shelf runner
F2 appears in the clock dis-
play
Door not properly closed or
door lock defective
Close door properly;
Turn the appliance off and
on again via the house fuse
or the safety switch in the
fuse box;
If displayed again, please
contact the Customer Care
Department
An error code not listed
above appears in the time
display
Electronic error Switch the appliance off
and on again by way of the
house wiring fuse or the
circuit breaker in the fuse
box.
If the display appears
again, please contact cus-
tomer service
To Next Page
Loading...
