AEG DBS 5573 User Manual

English
44
Operation
Before Initial Use
• Cleantheironingbasewithaslightlydampcloth.
• Inordertoremoveallresiduesbeforeinitialuse,please
pass the iron a few times over an old clean cloth.
Ironing without steam
NOTE:
• Sortoutthegarmentsaccordingtotheirironingtem-
peratures.
• Alwayssetthetemperaturecontrolto“MIN“ before
connecting the appliance to a power point, or before
disconnecting it.
• Ifthehandleshouldstillbeinthecarryingposition,
unlock the lock as described above under "Function of
the Handle".
• Placetheironontherest(6).
• Onlyconnectthemachinetoaproperlyinstalledsafety
socket,230V~,50Hz.
• Setthetemperatureonthetemperaturecontrol(2).Ifyou
have sensitive items to iron, please begin with the lowest
temperature.
NOTE:
The control lamp (10) on the iron shows that it is heating
up. As soon as the control lamp goes off the operating
temperature has been reached. Now you can start ironing.
• Alwaysturnthetemperaturecontrolto“MIN“ after
use and remove the mains plug (the control lamp in the
handle goes off).
Steam Ironing
WARNING:
The iron expels a large quantity of hot steam. Danger of
burns.
CAUTION:
• Whenusingthesteamironpleaseensurethatthe
water tank is always filled to the required level.
• Thelimeltercartridgealwayshastobepositionedin
the water tank, even if you use distilled water.
CAUTION: INITIAL USE:
Please proceed as follows:
• Thetankshouldonlybelleduptothemaximum
mark. Do not overfill!
• Closethewatertankandplaceitbackinthebase.
• Connectthebasestationtoa230V/50Hzsocketwith
earthing contact The tank illumination indicates readi-
ness for steam ironing.
• Setthedesiredtemperaturewithintherange“ “ to
“ “.
The control lamp on the iron lights up.
• Waituntilthesoleplatehasheatedup.Oncethetem-
perature has been reached the control lamp goes off.
CAUTION: INITIAL USE:
• Pressthesteamjetbutton(1)foratleast1minute.As
an alternative, you can pull back the lock (12) to lock the
steam jet button (11). This time is needed for the steam
to reach the iron. A slightly louder noise of the pump is
normal with this.
NOTE ON STEAM IRONING:
If the temperature control is set to less than “ “ the
production of steam is prevented.
Vertical Steam function (Vertical Steam)
This can be used to produce a jet of steam in a vertical
direction. This function can be used to remove creases from
hanging clothes or from curtains.
WARNING:
Never point the steam jet at other people. Danger of
burns.
Hang your laundry on a clothes hanger and move the iron to
approximately 5-15 cm away.
How can I replenish the water dur-
ing operation?
Refill with water before the tank is
completely empty. A loud noise of
the pump during operation indicates
that the water level is too low.
• Placetheironontherest(6).
• Setthetemperaturecontrolto“MIN“.
• Removethemainsplugfromthesocket.
• Inordertoremovethetank,pressthe
RELEASE button below the water tank.
(Fig. C).
• Removethelimeltercartridge(Fig.D).
• Fillthetankuptothemaximummark
(Fig. E). Do not overfill!
• Reinsertthelimeltercartridgeand
push the tank back into the base
(Fig. F + G). A "click" confirms that the
water tank
has been
set correctly.
• Youcan
now
continue
ironing.
NOTE:
The tank illumination lights once the mains plug has been
inserted into the outlet. If it does not light, the lime filter
cartridge or the water tank has not been set correctly.
Check both positions.

AEG DBS 5573 Specifications

General

Brand	AEG
Model	DBS 5573
Category	Iron
Language	English