English
43
• Children shall not play with the appliance.
• Cleaninganduser maintenance shall not be made by children
without supervision.
Intended Use
This appliance is intended for ironing of clothing and textiles.
It is intended for use in households.
Any other use shall be considered as not intended use and
can lead to material damage or even personal injury.
Overview of the Components
1 Steam jet button
2 Temperature control
3 Connecting tube
4 Mains lead
5 Base
6 Iron rest
7 Releasing device for handle “UNLOCK“
8 Water tank with lime filter
9 Handle
10 “Temperature“ control lamp
11 Steam jet button
12 Lock for continuous steam
13 Lime filter cartridge
not shown
RELEASE button below the water tank. Releasing device of
the water tank
Instructions
Unpacking
• Removeanyprotectivefoilsandstickersfromthesole-
plate.
• Pleaseunwindtheleadcompletely.
Electrical connection
• Makesurethattheironvoltage(seenameplate)andthe
line voltage match.
• Themainsplugshouldonlybeinsertedintoacorrectly
installed230V~50Hzsocketwithearthingcontact.
Power Requirements
The station has a total maximum wattage of 2200 W. With
this connected load a separate supply line protected by a
16 A household circuit breaker is recommended.
CAUTION: OVERLOAD!
• Ifyouuseextensionleads,theseshouldhaveacable
cross-section of at least 1.5 mm²
• Donotuseanymultiplesockets,asthisdeviceistoo
powerful.
Function of the Handle (9)
The handle attached to the base
serves for carrying the appliance
when the mains plug has been
pulled from the outlet.
• Tocarrytheappliance,raisethe
handle until it engages (Fig. A). A
"click" confirms that the handle
has been locked. You can use
the handle for transport of the
appliance.
• Tounlockthehandlelock,press
both buttons "UNLOCK" (7) at
the same time and lower the
handle (Fig. B).
Temperature Control on the Iron (2)
The symbols on the control correspond to the following
settings:
MIN Off
(Synthetics) low temperature
(Wool, Silk) medium temperature
(Cotton) high temperature
(Linen) highest temperature
Water Tank (8)
• Thewatertankhasarecessedgriponthebottomsothat
it can be removed.
• Thelockofthewatertankisalsothelimeltercartridge.
Take out the lime filter cartridge to fill with water. With
this, proceed as described under "How can I replenish
the water during operation?".
• Thetankvolumeis1.0litres.
• Thetankilluminationlightsoncethemainsplughas
been inserted into the outlet. It indicates readiness for
steam ironing when the lime filter cartridge and the water
tank have been set correctly.
Water
Use only tap water or distilled water.
Do not fill battery water, water from the clothes dryer and
water containing additives (such as starch, perfume, softener
or other chemicals) into the water reservoir.
This could damage the iron due to residues forming in the
steam chamber. These residues may cause impurities to the
fabric when dropping out of the holes in the soleplate.