64
Warning
• Failure to observe the instructions on cleaning the unit and changing
the filters will cause a fire hazard. You are therefore strongly
recommended to follow these instructions.
• The manufacturer declines all responsibility for any damage to the
motor or any fire damage linked to inappropriate maintenance or
failure to observe the above safety recommendations.
Changing the light bulb
• Disconnect the cooker hood from
the mains supply.
• Remove the lamp, use a screw driver
as a lever. Fig. 7.
• Remove the connector.
• Replace the old bulb with a new one
of the same type.
• Refit the connector.
• If the light does not come on, make
sure the bulb has been inserted
correctly before contacting your local
Service Force Centre.
Changing the upper light – DD 8765
• Disconnect the cooker hood from the mains supply.
• Remove the light cover by
unscrewing the two side screws
(hold the light cover when
carrying out this operation so
that it does not fall).
• Pull the light to the left to remove
it from its seat.
• Replace the old bulb with a new
one of the same type.
• If necessary change the
STARTER (bayonet fixed).
• Refit the light cover.
• If the light does not come on,
make sure the bulb has been
inserted correctly before
contacting your local Service
Force Centre.
Connector
Fig. 7
Fig. 8
Light cover
Light
Starter
To Next Page
Loading...
