EasyManua.ls Logo

AEG DVE5960HW - Controls and Lighting; Control Panel Overview; Filter Saturation Management

AEG DVE5960HW
192 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
www.aeg.com
6
5. CONTROLS

aspiration speed selection control and a
light switch to control cooking area lights.
Use the high suction speed in cases
of concentrated kitchen vapours. It is
recommended that the cooker hood suction
is switched on for 5 minutes prior to cooking
and to leave in operation during cooking
and for another 15 minutes approximately
after terminating cooking.
The control switches are located on the
unit’s front panel:
      
1 Speed ON/OFF button

2 
3 
4 
5 
Note: suction speed (power) key 4 has
a limited duration of 5 minutes, after
which the previous suction speed is
reactivated.
6 
(Room ventilation)
The hood switches on at low suction
speed (power) for 60 minutes, after
which it switches off.
7 

8 Hob2
H

9 

With the hood in standby, press key 1 , all
led lights will switch off: the control panel
is off.
Press key 1 again, all led lights will turn
on: the control panel is active.


With the hood in standby, press key 5 for
longer than 3 seconds
Key 7 

Key 7 will remain lit to indicate that

deactivated.


At regular intervals and depending on
the hood temperature, key 7 lights

be maintained in accordance with the
instructions in the relative paragraphs.
Key 7 

Key 7 


With the hood in standby, press key 7 for
longer than 3 seconds.
Repeat the operation if necessary.

Table of Contents

Related product manuals