8.2 How to fill the rinse aid
dispenser
CAUTION!
Only use rinse aid
specifically designed for
dishwashers.
1. Open the lid (C).
2. Fill the dispenser (B) until the rinse
aid reaches the marking ''MAX''.
3. Remove the spilled rinse aid with an
absorbent cloth to prevent too much
foam.
4. Close the lid. Make sure that the lid
locks into position.
Fill the rinse aid dispenser
when the indicator (A)
becomes clear.
If you use multi-tablets and
the drying performance is
satisfactory, the rinse aid
refill indication can be
disabled.
We recommend to always
use rinse aid for better
drying performance, also in
combination with multi-
tablets containing rinsing
agent.
9. DAILY USE
1. Open the water tap.
2. Press the on/off button to activate
the appliance.
Make sure that the appliance is in
programme selection mode.
• If the salt indicator is on, fill the
salt container.
• If the rinse aid indicator is on, fill
the rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Set and start the correct programme
for the type of load and the degree
of soil.
9.1 Comfort Lift
CAUTION!
Do not sit on th e rack. Do
not put excessive pressure
on locked basket.
CAUTION!
Do not exceed the max load
capacity (18 kg).
CAUTION!
Only use detergent
specifically designed for
dishwashers.
To ensure symmetric
unlocking on both sides, lift
the trigger handle
completely and the basket
slightly until the basket is
disengaged on both sides.
The Comfort Lift mechanism allows to lift
the lower rack up (to the second rack
level) and down to load and unload
dishes easily.
To extract the lower basket from the
lower position:
1. To lift the basket pull the rack out of
the dishwasher by the rack handle.
The trigger handle should not be
used.
www.aeg.com
38
Downloaded from www.vandenborre.be
To Next Page
Loading...
