The display shows the default option
value in parenthesis.
4. Press to change the value from
OFF to ON or vice versa.
If you select Delay and press , the
display shows the number of hours
available for the delay start. Select the
desired delay time and press
to
confirm.
5. Press repeatedly until the display
shows the selected programme.
7.3 XtraDry
Activate this option to boost the drying
performance.
XtraDry is a permanent option for all
programmes other than ECO 50°. It is
automatically activated in next cycles.
This configuration can be changed at any
time.
Every time ECO 50° is
activated, XtraDry is off and
needs to be chosen
manually.
Activating XtraDry deactivates TimeSaver
and vice versa.
7.4 TimeSaver
TimeSaver allows to reduce the duration
of a selected programme by
approximately 50%.
This option increases the pressure and
the temperature of the water. The
washing and the drying phases are
shorter.
The washing results are the same as with
the normal programme duration. The
drying results can decrease.
Activate TimeSaver the following way:
Select a programme and press
.
If TimeSaver is applicable to the selected
programme, the display shows two
values with corresponding programme
durations.
• Fast: select the value to activate
TimeSaver and press to
confirm.
• Normal: select the value to
deactivate TimeSaver and press
to confirm.
Activating TimeSaver deactivates XtraDry
and vice versa.
8.
BEFORE FIRST USE
When you activate the appliance for the
first time, you need to set the language.
The default language is English.
1. Set the language.
• Press to confirm English.
• Select a different language and
press
to confirm.
2. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water
softener.
3. Fill the salt container.
4. Fill the rinse aid dispenser.
5. Open the water tap.
6. Start a programme to remove any
residuals from the manufacturing
process. Do not use detergent and
do put dishes in the baskets.
After starting the programme, the
appliance recharges the resin in the
water softener for up to 5 minutes. The
washing phase starts only after this
procedure is complete. The procedure is
repeated periodically.
8.1 The water softener
The water softener removes minerals
from the water supply, which would have
a negative effect on the washing results
and on the appliance.
The higher the content of these minerals,
the harder your water is. Water hardness
is measured in equivalent scales.
The water softener should be adjusted
according to the hardness of the water in
your area. Your local water authority can
advise you on the hardness of the water
in your area. It is important to set the
ENGLISH
13
To Next Page
Loading...
Need help?
General
