Why I cannot activate or operate my AEG HDB64623NB Hob?
If the hob won't turn on, first check that it's properly connected to the electrical supply, referring to the connection diagram. Also, verify the fuse hasn't blown. If the fuse repeatedly blows, contact a qualified electrician. Ensure you're only touching one sensor field at a time and that the control panel is clean from water or fat stains.
What to do if the residual heat indicator does not come on on my AEG Hob?
If the residual heat indicator doesn't turn on, it could be because the zone hasn't been hot for very long. If the zone was used long enough to be hot, contact an Authorised Service Centre. It may also be due to the power management function operating; in this case, remove any objects from the sensor field.
What to do if there is no cookware on the zone of my AEG Hob?
Place cookware on the zone.
What to do if my AEG HDB64623NB Hob is beeping and turning off?
If the hob gives an acoustic signal and deactivates, it might be because something is placed on one or more of the sensor fields. Remove any objects from the sensor fields.
How to fix no spark when trying to activate the spark generator on my AEG HDB64623NB?
If there's no spark when activating the spark generator on your AEG hob, check if the hob is correctly connected to the electrical supply. Also, see if the fuse is blown and replace it if necessary; if it blows repeatedly, contact an electrician. Ensure the burner cap and crown are correctly placed.
Why does the flame extinguish immediately after ignition on my AEG Hob?
If the flame extinguishes immediately after ignition on your AEG hob, it could be that the thermocouple isn't heating up enough. After lighting the flame, keep the knob pushed for equal or less than 10 seconds. Also, ensure that the injector is not blocked and the burner crown is clean.
Why do the sensor fields become hot on my AEG HDB64623NB?
The sensor fields might become hot if the cookware is too large or placed too close to the controls. If possible, put larger cookware on the rear zones.
What to do if there is an error in my AEG Hob?
If there is an error in the hob, disconnect it from the electrical supply for some time. Disconnect the fuse from the electrical system of the house. Connect it again.
Why is the flame ring uneven on my AEG HDB64623NB Hob?
The burner crown might be blocked with food residues.
General| Type | Induction |
|---|---|
| Number of Cooking Zones | 4 |
| Width | 59 cm |
| Control Type | Touch |
| Power Levels | 14 |
| Boost Function | Yes |
| Colour | Black |
| Total Power | 7400 W |
| Residual Heat Indicator | Yes |
| Child Safety Lock | Yes |
| Timer | Yes |
| Power Slide Control | Yes |
| Installation Type | Built-in |
| Material | Glass Ceramic |
| Safety Features | Automatic switch off |
| Dimensions (W x D x H) | 590 x 520 x 46 mm |
To Next Page
