7.2 Pan supports
The pan supports are not
resistant to washing in a
dishwasher. They must be
washed by hand.
1. Remove the pan supports to easily
clean the hob.
Be very careful when
you replace the pan
supports to prevent the
hob top from damage.
2. After you clean the pan supports,
make sure that they are in correct
positions.
3. For the burner to operate correctly,
make sure that the arms of the pan
supports are inserted in the recesses
of the enamelled plates.
7.3 Removing and
assembling pan supports
After cleaning of the hob, make sure that
pan supports are in a correct position. In
order to place a pan support properly,
make sure that its arms fits the grips
placed at the base of the burner as
shown in the picture. This way, a pan
support is stable and fixed.
7.4 Cleaning the hob
• Remove immediately: melted plastic,
plastic foil, salt, sugar and food with
sugar, otherwise, the dirt can cause
damage to the hob. Take care to
avoid burns. Use a special hob
scraper on the glass surface at an
acute angle and move the blade on
the surface.
• Remove when the hob is
sufficiently cool: limescale rings,
water rings, fat stains, shiny metallic
discoloration. Clean the hob with a
moist cloth and a non-abrasive
detergent. After cleaning, wipe the
hob dry with a soft cloth.
• Remove shiny metallic
discoloration: use a solution of water
with vinegar and clean the glass
surface with a cloth.
• To clean the enamelled parts, caps
and crowns, wash them with warm
soapy water and dry them carefully
before you put them back on.
7.5 Cleaning the flame
spreader
You can wash the flame
spreaders in a dishwasher.
WARNING!
Let the flame spreaders cool
down before you clean them.
Light stains:
Wash the flame spreader with warm
water and soap and dry it with a soft
cloth.
Medium stains:
Use the dishwasher. Place the flame
spreader on the bottom rack in a flat
position, with the top side up.
Heavy stains:
Clean the flame spreader with warm
water and soap, then wash it in the
dishwasher. If the stain is still present
wash the top of the flame spreader with a
grill cleaner and run through the
dishwasher again.
Use a toothpick to clean the holes of the
flame spreader.
7.6 Cleaning the spark plug
This feature is obtained through a
ceramic ignition candle with a metal
electrode. Keep these components well
clean to prevent difficult lighting and
check that the burner crown holes are
not obstructed.
www.aeg.com26
To Next Page
Loading...
