To activate the function: activate the hob
with . Do not set any heat setting. Touch
for 4 seconds. comes on.
Deactivate the hob with .
To deactivate the function: activate the hob
with
. Do not set any heat setting. Touch
for 4 seconds. comes on.
Deactivate the hob with .
To override the function for only one
cooking time: activate the hob with
.
comes on. Touch for 4 seconds. Set
the heat setting in 10 seconds. You can
operate the hob. When you deactivate the
hob with the function operates again.
5.10 OffSound Control (Deactivating
and activating the sounds)
Deactivate the hob. Touch for 3 seconds.
The display comes on and goes out. Touch
for 3 seconds. or comes on.
Touch of the timer to choose one of the
following:
• - the sounds are off
•
- the sounds are on
To confirm your selection wait until the hob
deactivates automatically.
When the function is set to
you can hear
the sounds only when:
• you touch
• Minute Minder comes down
• Count Down Timer comes down
• you put something on the control panel.
5.11 Power management
If multiple zones are active and the
consumed power exceeds the limitation of the
power supply, this function divides the
available power between all cooking zones
(connected to the same phase). The hob
controls heat settings to protect the fuses of
the house installation.
• If the hob reaches the limit of maximum
available power (refer to the rating plate),
the power of the cooking zones will be
automatically reduced.
• The heat setting of the cooking zone
selected last is always prioritised. The
remaining power will be divided between
the previously activated cooking zones in
reverse order of selection.
• The heat setting display of the reduced
zones changes between the initially
selected heat setting and the reduced heat
setting.
• Wait until the display stops flashing or
reduce the heat setting of the cooking
zone selected last. The cooking zones will
continue operating with the reduced heat
setting. Change the heat settings of the
cooking zones manually, if necessary.
6. FLEXIBLE INDUCTION COOKING AREA
WARNING!
Refer to Safety chapters.
6.1 FlexiBridge function
The flexible induction cooking area consists
of four sections. The sections can be
combined into two cooking zones with
different size, or into one large cooking area.
You choose the combination of the sections
by choosing the mode applicable to the size
of the cookware you want to use. There are
three modes: Standard (activated
automatically when you activate the hob), Big
Bridge and Max Bridge.
To set the heat setting use two left side
control bars.
Switching between the modes
32 ENGLISH
To Next Page
Loading...
