Problem Possible cause Remedy
The diameter of the bottom of the
cookware is incorrect for the activa‐
ted function or function mode.
Use cookware with a diameter applica‐
ble to the activated function or function
mode. Refer to "Flexible induction
cooking area".
comes on.
There is no cookware on the zone. Put cookware on the zone.
The cookware is unsuitable. Use cookware suitable for induction
hobs. Refer to "Hints and tips".
The diameter of the bottom of the
cookware is too small for the zone.
Use cookware with correct dimen‐
sions. Refer to "Technical data".
FlexiBridge (Flexible Bridge) oper‐
ates. One or more sections of the
function mode which operates are
not covered by the cookware.
Place the cookware on the correct
number of sections of the function
mode which operates or change the
function mode. Refer to "Flexible in‐
duction cooking area".
PowerSlide operates. Two pots are
placed on the flexible induction
cooking area or the cookware covers
more than one cooking area activa‐
ted by the function.
Use only one pot. Refer to "Flexible in‐
duction cooking area".
and a number come on.
There is an error in the hob. Deactivate the hob and activate it
again after 30 seconds. If comes
on again, disconnect the hob from the
electrical supply. After 30 seconds,
connect the hob again. If the problem
continues, speak to an Authorised
Service Centre.
9.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Give also three digit letter code for the
glass ceramic (it is in the corner of the glass
surface) and an error message that comes
on. Make sure, you operated the hob
correctly. If not the servicing by a service
technician or dealer will not be free of charge,
also during the warranty period. The
information about guarantee period and
Authorised Service Centres are in the
guarantee booklet.
10. TECHNICAL DATA
10.1 Rating plate
Model IKE64476FB PNC 949 597 998 00
Typ 62 B4A 05 AA 220 - 240 V / 400 V 2N, 50 - 60 Hz
Induction 7.35 kW Made in: Germany
Ser.Nr. ................. 7.35 kW
AEG
ENGLISH 39
To Next Page
Loading...
