Use two left side control bars.
Correct cookware position:
To use this mode you have to place the
cookware on the three connected
sections. If you use cookware smaller
than two sections the control bar blinks
and after 2 minutes the zone switches off.
Incorrect cookware position:
7.4 FlexiBridge Max Bridge
mode
To activate the mode touch until you
see the correct mode indicator . This
mode connects all sections into one
cooking zone. To set the heat setting use
any of the two control bars on the left
side.
Correct cookware position:
To use this mode you have to place the
cookware on the four connected
sections. If you use cookware smaller
than three sections the control bar blinks
and after 2 minutes the zone switches off.
Incorrect cookware position:
7.5 PowerSlide
This function allows you to adjust the
temperature by moving the cookware to
a different position on the induction
cooking area.
The function divides the induction
cooking area into three areas with
different heat settings. The hob detects
the position of the cookware and adjust
the heat setting corresponding with the
ENGLISH
15
To Next Page
Loading...
