5. BEFORE FIRST USE
WARNING!
Refer to Safety chapters.
5.1 Initial Cleaning
Remove all accessories and removable
shelf supports from the oven.
Refer to "Care and cleaning" chapter.
Clean the oven and the accessories
before the first use.
Put the accessories and the removable
shelf supports back to their initial
position.
5.2 First Connection
After the first connection the software
version will appear for 7 seconds.
You have to set the language, the
Display Brightness, Water hardness and
the Time of Day.
5.3 Setting the water hardness
The table below shows the water
hardness range (dH) with the
corresponding Calcium deposit and the
quality of the water.
Water hardness Calcium deposit
(mmol/l)
Calcium deposit
(mg/l)
Water classi-
fication
Class dH
1 0 - 7 0 - 1.3 0 - 50 Soft
2 7 - 14 1.3 - 2.5 50 - 100 Moderately
hard
3 14 - 21 2.5 - 3.8 100 - 150 Hard
4 over 21 over 3.8 over 150 Very hard
When the water hardness exceeds the
values in the table, fill the water drawer
with bottled water.
1. Take the 4 colour change strip
supplied with the steam set in the
oven.
2. Put all the reaction zones of the strip
into the water for approximately 1
second.
Do not put the strip into the running
water.
3. Shake the strip to remove the excess
of the water.
4. Wait 1 minute and check the water
hardness with the table below.
The colours of the reaction zones
continue to change. Do not check
the water hardness later than 1
minute after test.
5. Set the water hardness: menu: Basic
Settings.
Test strip Water hardness
1
2
3
4
You can change the water hardness in
the menu: Basic Settings / Setup / Water
hardness.
ENGLISH
9
To Next Page
Loading...
Need help?
General
