To Next Page
L
Lucas BergerAug 16, 2025
Why AEG LAVATHERM T57830 does not work?
- CCory HallAug 16, 2025
If the dryer isn't working, ensure the loading door is fully closed. If it is, try pressing the START/PAUSE button again to start the cycle.
Why AEG LAVATHERM T57830 does not work?
If the dryer isn't working, ensure the loading door is fully closed. If it is, try pressing the START/PAUSE button again to start the cycle.
What to do if my AEG LAVATHERM T57830 Dryer cycle ends shortly after it starts?
If the drying cycle ends soon after starting and the END display is illuminated, it could be due to insufficient washing loaded or the washing being too dry for the selected programme. Try selecting a time programme or a higher drying level, such as INTENSIVE DRY instead of STORAGE DRY.
How to open the loading door on my AEG Dryer if the DOOR button doesn't work?
If the loading door doesn't open with the DOOR button, make sure the dryer is plugged in. Also, check that the programme selector is not in the OFF position; set a programme. You can open the loading door at any time by exerting pressure on the door.
Why is my AEG Dryer taking so long to dry?
Several factors can cause a drying cycle to last longer than usual. The lint filter or heat exchanger might be clogged and require cleaning. If you have the SPECIAL CARE button pressed, ensure the load is no more than 3 kg. Also, the load volume might be too big, or the laundry was insufficiently pre-drained.
What to do if my AEG LAVATHERM T57830 Dryer drying results are unsatisfactory?
Unsatisfactory drying results may occur due to several reasons. Ensure that you have selected the correct programme. Check and clean the lint filter and heat exchanger if they are clogged. Avoid overloading the laundry, and make sure the ventilation slots in the base area are not covered. Clean any residue on the inside surface of the drum or drum ribs. If needed, make an adjustment using the INTENSITY function.
What to do if the AEG Dryer programme is inactive and the EMPTY WATER display is illuminated?
If the programme is inactive and the EMPTY WATER display is illuminated, the condensate tank is likely full. Empty the condensate tank and then press the START/PAUSE button to restart the programme.
What to do if my AEG LAVATHERM T57830 Dryer loading door does not close?
If the loading door does not close, check if the fine strainer is in place and the large mesh filter is locked. Install the fine strainer and snap the large mesh filter into place.
Why is the corresponding button flashing several times on my AEG Dryer?
When a button flashes several times, it indicates washing protection is active. Turn the programme knob to OFF and then set the programme again.
How to fix AEG Dryer drum light?
If the drum light does not work, ensure the programme selector is turned to LIGHT or any programme. If it still doesn't work, the light bulb may be defective and needs replacement.
Protect children from hazards associated with the dryer.
Important safety guidelines for using the appliance.
Guidelines for recycling packaging components.
Instructions for proper disposal of the old appliance.
Explanation of the control panel and display elements.
Steps to switch on, load laundry, and close the door.
How to choose a programme and additional drying options.
How to set a delayed start and initiate the drying cycle.
How to change programmes, add/remove laundry, and complete cycles.
How to clean the micro-fine filter and fine strainer.
How to clean the dryer's door seal.
Steps to empty the condensate tank after each cycle.
Instructions for cleaning the heat exchanger.
Steps to diagnose and fix issues using the manual.
Details on energy and water consumption for various programmes.
Critical safety measures during appliance installation.
Steps to remove transit restraints before first use.
How to properly connect the dryer to the power supply.
Guidelines for making a fixed electrical connection.
General