How to fix an AEG LX5-2-2SW Vacuum Cleaner that won't start?
If your AEG Vacuum Cleaner isn't starting, there are a few things you can check. First, make sure the cable is properly connected to the mains. Next, inspect the plug and cable for any signs of damage. Finally, check your fuse to see if it has blown.
Why does my AEG LX5-2-2SW have reduced suction?
If your AEG Vacuum Cleaner isn't picking up dirt as well as it used to, several factors could be responsible. First, examine the dust container to ensure it isn't full or blocked. Next, check the nozzle, tube, hose, and filters for any obstructions. Also, make sure the dust container and filters are correctly installed. Try cleaning or replacing the filters. Finally, if the hose is damaged, replacing it will be necessary.
What to do if water was sucked into my AEG LX5-2-2SW Vacuum Cleaner?
If water has been sucked into your AEG Vacuum Cleaner, the motor may be damaged. In this case, the motor will need to be replaced at an authorized Electrolux service center. Please note that motor damage caused by water is not covered under warranty.
General| Brand | AEG |
|---|---|
| Model | LX5-2-2SW |
| Category | Vacuum Cleaner |
| Language | English |
To Next Page
