What to do if my AEG LX5 Vacuum Cleaner stops working?
If your AEG Vacuum Cleaner stops, it might be overheated. Disconnect it from the mains and check if the nozzle, tube, hose, or filters are blocked. Allow the cleaner to cool down for 30 minutes before plugging it back in. If it still doesn't work, contact an authorized Electrolux service center.
How to fix an AEG LX5 that does not start?
If your AEG Vacuum Cleaner does not start, first check that the cable is properly connected to the mains. Then, inspect the plug and cable for any damage. Finally, check the fuse to see if it has blown.
What to do if water has been sucked into my AEG LX5?
If water has been sucked into the vacuum cleaner, it will be necessary to replace the motor at an authorized Electrolux service centre. Damage to the motor caused by the penetration of water is not covered by the warranty.
Why does my AEG LX5 have reduced suction capacity?
If your AEG Vacuum Cleaner's suction capacity is reduced, check if the dust container is full or blocked. Also, inspect the nozzle, tube, hose, and filters for blockages. Ensure the dust container and filters are correctly in place. Clean or replace the filters as needed. If the hose is damaged, it should be replaced.
Why is my AEG LX5 overheated?
Your AEG Vacuum Cleaner may be overheating because the dust container is full or blocked. Empty the dust container. Also, clean or replace the filters.
Guidelines for children's use and maintenance, emphasizing supervision and prohibiting independent cleaning.
Instructions on electrical safety, avoiding liquids, checking hose condition, and usage limitations for domestic use.
Precautions for the power cord, including regular checks for damage, replacement by authorized centers, and avoiding lifting by the cord.
Specific warning for turbo nozzles with rotating brushes, advising caution and proper handling to prevent entrapment.
Solutions for when the vacuum cleaner fails to start, checking power connections, fuses, and potential overheating.
Steps to resolve the cleaner stopping, including checking dust container, filters, and blockages in the nozzle, tube, or hose.
Diagnosing and fixing low suction by checking dust container fullness, filter blockages, and ensuring parts are correctly fitted.
Instructions on how to clear obstructions from the hose, with a caution for sharp objects like glass or needles.
Guidance for an overheated vacuum cleaner, recommending disconnection, checking for blockages, and allowing cool-down time.
Addressing issues when water is sucked into the cleaner, noting that motor damage from water is not covered by warranty.
General| Maximum input power | 750 W |
|---|---|
| Annual energy consumption | 28 kWh |
| Type | Cylinder vacuum |
| Cleaning type | Dry |
| Dust capacity | 1.8 L |
| Product color | Black |
| Number of wheels | 3 wheel(s) |
| Dust container type | Bagless |
| Proper use | Home |
| Noise level | 80 dB |
| Cleaning surfaces | Carpet, Hard floor |
| Vacuum air filtering | - |
| Dirt separating method | Filtering |
| Crevice tool | Yes |
| Vacuum brushes included | Dusting brush |
Weight and Dimensions| Weight | 4500 g |
|---|
To Next Page
