EasyManua.ls Logo

AEG PX71-265WT - 2. SAFETY INSTRUCTION; 2.1 Notes on Operation

AEG PX71-265WT
96 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
www.aeg.com
• To ensure proper drainage, the drainage hose must
have no kinks and must not be elevated during
dehumidi󰘰catioin mode. If not, the drained water may
spill out into the room.
• The temperature around the drainage hose must not
be below freezing point when used. Drained water may
freeze inside the hose, causing water inside the unit to
over󰘱ow into the room.
• Do not block the exhaust air outlet with obstacles. Cooling
performance may be reduced or stop completely.
• Provide a residual current device (ROD) in order to
protect against electric shock in accordance with British
Standard and Wiring Rules.
• Exposure to direct air󰘱ow for an extended period of
time could be hazardous to your health. Do not expose
occupants, pets, or plants to direct air󰘱ow for extended
periods of time.
• Do not use this air conditioner for non-speci󰘰ed special
purposes (e.g. preserving precision devices, food, pets,
plants, and art objects). Usage in such a manner could
harm such property.
2.
SAFETY INSTRUCTION
2.1 Notes on Operation
• Allow 3 minutes for the compressor
to restart cooling. If you turn the air
conditioner o󰘯 and immediately restart
it, allow 3 minutes for the compressor
to restart cooling. There is an electronic
device in the unit that keeps the
compressor turned o󰘯 for 3 minutes
for safety.
• In the event of a power failure during
use, allow 3 minutes before restarting
the unit. After power is reinstated,
restart the air conditioner. If the power
was o󰘯 for less than three minutes,
be sure to wait at least three minutes
before restarting the unit. if you
restart the air conditioner within three
minutes, a protective device in the unit
may cause the compressor to shut o󰘯.
This protective device will prevent
cooling for about 5 minutes. Any
previous setting will be cancelled and
the unit will return to its initial setting.
• Low temperature operation: Is your
unit freezing up? Freezing may occur
when the unit is set close to 18°C in
low ambient temperature conditions,
especially at night. In these conditions,
a further temperature drop may cause
the unit to freeze. Setting the unit to a
higher temperature will prevent it from
freezing.
• Dehumidi󰘰cation mode increases
room temperature. The unit generates
heat during dehumidi󰘰cation mode
and the room temperature will rise.
Warm air will be blown out from the
exhaust air outlet, but this is normal
and does not indicate a problem with
the unit.
• This air conditioner blows the warm air
generated by the unit outside the room