1. Remove the accessories in front of the
water module and open the service
hatch.
2. Place a cloth or a piece of kitchen towel
in the space beneath the water filter.
3. Pull the bypass cartridge outwards,
grasping the lower part, until the water
bypass cartridge is automatically ejec-
ted.
4. Remove the protective wrapping of the
new water filter and insert the new fil-
ter firmly into the filter connection.
5. Push the water filter back to its original
position.
6. Remove cloth or towel and make sure
that spilled water is wiped off.
7. Close the hatch and remount the interi-
or.
8. Keep the bypass cartridge for future use.
9. Unlock the water dispenser. Refer to
"Child lock functions". Select plain water
and dispense about 2 litres of water.
There may be some air to start with.
Installation of the gas cylinder
1. Remove the gas cylinder wrapping and
screw on the adapter to the gas cylin-
der. Tighten by hand only.
Installation 25
To Next Page
Loading...
