AEG SOLO 10 - Phone Installation Procedures; Base Station Setup; Battery Installation and Charging

3
3.2 Handset & Base Connection
•When purchased, all handsets are already registered to the base unit and should link to it when they are
all powered up.
•To use your cordless handset and base unit together, you must be able to establish a radio link between
them. The signal between the handset and the base unit is in accordance with the normal standards for
a DECT phone: Maximum range up to 300 metres outdoors or 50 metres indoors. Be aware that:
>Large metal objects, such as refrigerators, mirrors or filing cabinets, between the handset and the base
unit may block the radio signal.
>Solid structures, such as walls, may reduce the signal strength.
>Electrical equipment may cause interference and/or affect the range.
•Do not place the base unit close to another telephone, TV or audio equipment - it may cause interference.
•Putting the base unit as high as possible ensures the best signal.
•Out of Range warning. If you hear a warning tone during a call, and/or the sound in the earpiece becomes
faint or distorted, you may be going out of range of the base unit. Move nearer to the base unit within
20 seconds; otherwise the line may be cut off.
4 INSTALLING YOUR PHONE
4.1 Connecting the Base Station (See P4)
•Plug the mains power cable (16) and telephone line cord (15) into the base station.
•Plug the power adapter into a 100 - 240Vac, 50 - 60Hz mains power socket, and the telephone line cord
into a telephone line socket.
•Always use the cables provided in the box.
Warning:
Use only the supplied adaptor. Using other power cables may damage the unit.
Warning:
Place the base unit within easy reach of the mains power socket. Never try to lengthen the mains power
cable.
Note:
The base station must be plugged into the mains power at all times.
4.2 Installing and Charging the Rechargeable Batteries (See P5)
•Insert the 2 supplied batteries into the battery compartment, observing the correct polarity (see marking
inside battery compartment).
•Align the back cover tabs with the notches located at the edges of the exposed back panel and press
down to snap into place.
•Place the handset on the base and charge for 15 hours before using the handset for the first time.
>The handset will give a beep when it is properly placed on the base or charger.
>The battery charging indicator on the base or charger lights up in Red to indicate charging.
Warning:
Use only the supplied NiMH rechargeable batteries.
Note:
The handset may become warm when the batteries are being charged or during prolonged periods of
use. This is normal and does not indicate a fault.
CAUTION
Risk of explosion if the battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.