AEG SOLO 10 - Basic Phone Operations; Text and Number Entry; Making Phone Calls

6
UK
5.5 Text and Number Entry
The following table shows you where each letter and punctuation character can be found, by using
repeated presses of the alphanumeric keypad. This will be helpful when storing a name in the phonebook
or renaming your handset.
For example, to enter the name Tom :
T Press 8 once
O Press 6 three times
M Press 6 once
In editing mode, a cursor is displayed to indicate the current text entry position.
It is positioned at the right of the last character entered.
Writing Tips:
Once a character is selected, the cursor will move to the next position after a short pause.
Press
to delete the last letter or number.
6 SET THE DISPLAY LANGUAGE
You can select different display languages.
•From the home screen, press .
•Press to “PERSONAL SET” and then press to select.
•Press to “LANGUAGE” and then press to select.
•Press to select your preferred language and then press to confirm.
>A confirmation beep is played.
•Press
to return to standby mode.
Note:
Once the display language is set, the handset will switch to display in the selected language immediately.
7 USING YOUR PHONE
7.1 Make a Call
7.1.1 Pre-dialling
•Enter the phone number (maximum 24 digits).
•If you make a mistake, press
to delete the last entered number.
•Press
to dial the phone number.
7.1.2 Direct Dialling
•Press
.
•Dial the number (maximum 24 digits).
Note:
If you make a mistake, you cannot correct it with the
key.
Press
and then press to return to the home screen.
7.1.3 Call from the Redial List
•Press
key in standby mode.
>The last number dialled is displayed.
•Press
to select the desired entry in the redial list and then press to dial out the selected redial
number.