AEG STYLE 12 - Installation

4
8
Mute button
9
Delete button
10
/
Set / store button
11
Speakerphone volume switch
12
Ringer high/low switch
5 INSTALLATION
1. Locating the base unit (see P2 and P3)
The base unit should be placed on a level surface, in a position where:
tthe telephone line cable will reach your telephone line socket or extension socket.
tit is not close to a sink, bath or shower, or anywhere else where it might get wet.
tit is not close to other electrical equipment - fridges, washing machines, microwave ovens, TVs,
fluorescent lights, etc.
2. Installing (or replacing) the batteries (see P4)
IMPORTANT:
Before removing the battery compartment cover, always make sure the base unit is disconnected from
the telephone line.
tInstall 3 Alkaline AAA batteries into the battery compartment and place back the cover before use.
Note:
1) Please do NOT use rechargeable batteries in this phone.
2) Batteries are not included with the unit.
3) The battery life is typically about 6 months, depending on usage.
When the battery is low?
will show up on the display screen. If you do not replace the batteries,
they will become totally discharged and your display screen will not work. You may lose all the
telephone memories and settings.
3. Plug the coiled handset cord into the handset. Plug the other end into the jack on the left side
of the base unit.
4. Place the handset in the base unit.
5. Plug the telephone line cord free end into a modular wall jack. Press the cable into the groove
so that the base unit stands level.
6. Lift the handset and check for dial tone in the handset.