AEG T6DB72GP - Adjustment of Default Dryness Level; Deactivating the Tank Indicator; Care and Cleaning

must first filter the water to eliminate
remaining textile fibres (simple coffee
filter is suitable).
• Always keep the airflow slots at the
bottom of the appliance clear.
• Make sure there is good airflow where
the appliance is to be installed.
9.2 Adjustment of default
dryness level
To change the default dryness level:
1. Turn the appliance on.
2. Wait approximately 8 seconds.
3. Select 1 of the available
programmes.
4. Touch and hold down the
Droogtegraad and Anti-kreuk
buttons at the same time.
One of the symbols appears on the
display:
- Maximum dryness
- Extra dryness
- Standard dryness
5. Touch the Start/Pauze button
repeatedly until you reach the
desired dryness level.
Dryness
level
Display symbol
Maximum
dryness
Extra dry‐
ness
Dryness
level
Display symbol
Standard
dryness
6. To memorise the setting touch and
hold down the Droogtegraad and
Anti-kreuk buttons at the same time
for approximately 2 seconds.
9.3 Deactivating the tank
indicator
The water container indicator is activated
by default. It illuminates at the end of the
drying cycle or during the cycle if the
water reservoir is full. If the draining kit is
installed the water container is drained
automatically and the indicator can be
deactivated.
To deactivate the indicator:
1. Turn the appliance on.
2. Wait approximately 8 seconds.
3. Select 1 of the available
programmes.
4. Touch and hold down Anti-kreuk
and Tijd buttons at the same time.
One of 2 configurations is possible:
• the watertank indicator: is on if
the symbol appears - the
water container indicator is
permanently activated
• the watertank indicator:
is off if
the symbol appears - the
water container indicator is
permanently deactivated
10. CARE AND CLEANING
10.1 Cleaning the filter
At the end of each cycle the filter
symbol comes on the display and you
must clean the filter.
The filter collects the lint
during the drying cycle.
CAUTION!
Clogged filter leads to the
emergency heater
shutdown. As a
consequence the laundry
remains cold and wet. The
display shows 1 min or few
minutes to the cycle end for
a longer time.
The filter cleaning fixes
above problems.
www.aeg.com16