9. DAILY USE
9.1 Start a programme without delay
start
1. Prepare the laundry and load the
appliance.
CAUTION!
Make sure that when you close the
door, the laundry does not get caught
between the appliance door and the
rubber seal.
2. Press the on/off button to activate the
appliance.
3. Set the correct programme and options
for the type of load.
The display shows the programme duration.
Real drying time will depend on type of
the load (quantity and composition), the
room temperature and the initial moisture
after spinning phase of your laundry.
4. Press the Start/Pause touch button.
The programme starts.
9.2 Starting the programme with
delay start
1. Set the correct programme and options
for the type of load.
2. Press the delay start button again and
again until the display shows the delay
time you want to set.
You can delay the start of a
programme from a minimum of 30
minutes to a maximum of 20 hours.
3. Press the Start/Pause touchpad.
The display shows the countdown of the
delay start.
When the countdown is completed, the
programme starts.
9.3 Change a programme
1. Press the on/off button to deactivate
appliance
2. Press the on/off button to activate the
appliance.
3. Set the programme.
9.4 At the end of the programme
When the programme is completed:
• An intermittent acoustic signal operates.
• The indicator flashes.
• The indicator
flashes.
• The Start/Pause indicator is on.
The appliance continues to operate with the
crease guard phase for approximately other
30 minutes.
The crease guard phase prevents creases
from your laundry.
You can remove the laundry before the
crease guard phase is completed. We
recommend, for better results, that you
remove the laundry when the phase is almost
completed.
When the crease guard phase is completed:
• The indicator is on but does not flash.
• The indicator is on but does not flash.
• Start/Pause indicator goes off.
1. Press the on/off button to deactivate the
appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Possible causes of unsatisfactory drying
results:
• Inadequate default dryness level settings.
See chapter
Adjustment of default dryness
level
12 ENGLISH
To Next Page
Loading...
