AEG WSP 2010 - 1.3 Safety Instructions; 1.4 Care and Maintenance

For the User
22
1.3 Safety Instructions
AN
The unit must not
—
be
operated
in
rooms
where
there
is
a
risk
of
fire
or
explosion
due
to
chemicals,
dust,
gases
or
fumes;
—
be
operated
in
the
immediate
vicinity
of
pipes
or
containers
which
carry
or
contain
inflammable
or
explosive
substances;
- be operated when the minimum distances from adjacent object surfaces are not kept.
e
This
unit
must
only
be
installed
(electrical
installation),
commissioned
and
maintained
by
an
authorised
expert
according
to these
instructions.
e The unit must on no account be operated when work on floors such as laying, sanding, sealing,
cleaning with petrol and caring (spray, wax) and similar is being performed.
Then the room must be adequately aired before charging.
e
The
heater's
casing
surfaces
and
the
air
outlet
grille
can
heat
up
to
temperatures
above
80
°C.
Therefore
no inflammable,
ignitable
or
heat
insulating
objects
or materials
such as
washing,
blankets,
newspapers,
containers
of
floor
wax
or petrol,
aerosol cans
and
similar
may
be
placed
on or
in
the immediate
vicinity
of
the heater.
Washing
must
never be
hung over
the
heater
to
dry. Danger
of catching
fire!
e The following minimum distances must be kept from the heater by all kinds of objects, e.g.
furniture,
curtains
and
textiles
or
other
flammable
and
non-flammable
materials
especially
from
the air outlet grid (fig. 2):
to the air outlet grille => 500mm
from the right side wall (for installation clearance) > 100 mm
from the left side wall > 70 mm
from the left side wall with two storage heaters next to one another = 100mm
from the cover (e. g. window ledge) > 40 mm
from the cover (curtains, inflammable materials) => 100mm
The hot air must be able to discharge unhindered (fig. 19)!
e
The
label
enclosed
with
these
operating
and
installation
instructions
"Do
not
place
objects
on
or
lean
them
against
the heater"
must
be
affixed
well
visibly on
the
top of
the
heater
in
commercially
used
rooms
such as hotels,
holiday
homes,
schools
etc.
1.4 Care and Maintenance
If slight brown discoloration of the unit housing should occur, this should be rubbed off
immediately with a soft cloth.
The device should be cleaned cold with normal cleaners.
Abrasive and aggressive cleaners should be avoided.
Do not spray cleaning spray into the air vents.
The ventilation duct behind the air outlet grille (5) should be checked by a specialist every two
years. Slight dirt deposits may accumulate here.
We recommend that you have the inspection and control elements checked during regular
maintenance. Safety, inspection and control elements as well as the entire charging and discharge
control system should be checked by a specialist 10 years after first commissioning at the latest.
\
1.4.1 Cleaning the Fluff Screen (fig. 3)
The fluff screen (7) located in the air inlet grille (6) must be cleaned regularly,
so that fault-free discharging of the storage heater is guaranteed.
The fans switch off when the fluff screen is blocked.
Proceed as follows to clean the fluff screen.
— Press the air inlet grille (6} down slightly on both sides, tip forward at the front and remove;
- Press the fluff screen out of the grille with a screwdriver for example and clean with a brush,
vacuum cleaner or similar;
Replace the fluff screen in the grille and snap in the lugs.
- Place the air inlet grille at an angle on the lugs in the unit base and snap in under the air outlet
grille by pressing lightly (fig. 16).