AEG WSP 2010 - 1.5 Important Note

For the User and Fitter
1.5 Important Note
A
What to do when ...?
Keep
these
instructions
in
a
safe
place,
pass
on
to
the
new
owner
in
case
of
a
change
of
ownership.
Make
them
available
to
the
specialist
in
the
case
of
repair
work.
For the User
For the specialist
e the storage heater
does not get hot
e the storage heater
housing should get
extraordinarily
hot even in mild
weather
Check whether . . .
- the selector knob is set to
position 3.
. the corresponding fuses in
` your fuse box are defective or
the Fl switch has switched off.
Eliminate the cause!
If the following day the
storage heaters have still not
heated up, call a specialist.
Check whether...
... the fan can be switched on
with the room temperature
regulator.
If not, call a specialist.
. the fluff screen in the air inlet
grille is blocked.
Eliminate cause as described
in section 1.4.1!
Check whether ...
... the control of the heating
element contactor is OK.
. there is a voltage at terminals
L1/L2/L3.
. whether the safety temperature
limiter (F1) has triggered.
"CLIC"
Check whether ...
... the room temperature
regulator has switched on and
voltage is applied at terminal
LE.
. the fans are turning.
. the safety temperature
regulator "(N5, see page 3,
fig. 1) in the air outlet has
switched off.
. the control signal Z1 of the
charging control unit is applied
at terminal A1/Z1 in the
storage heater.
23
English