Need help?Do you have a question about the AEG X-SLIM 35 EC and is the answer not in the manual?
General| Type | Instantaneous water heater |
|---|---|
| Power | 3.5 kW |
| Voltage | 220-240 V |
| Water Connection | 1/2 inch |
| Frequency | 50/60 Hz |
| Protection class | IP25 |
| Heating element | Bare wire |
| Cable length | 1.5 m |
| Color | White |
Read these instructions carefully before using the appliance and retain them for future reference.
Appliance not for use by persons with reduced capabilities without supervision.
Children should be supervised to ensure they do not play with the appliance.
Illustrates the physical dimensions of the shower water heater unit.
Shows the cable connection and required length for installation.
Details the steps and requirements for securely mounting the unit on a wall.
Provides a schematic diagram illustrating the electrical connections of the unit.
Overview of the X-SLIM instantaneous water heater's features and electronic control.
Briefly outlines essential parts like the water valve and rotary control.
Highlights important information regarding unit pressure and scale removal.
Explains the ELCB and recommends monthly testing for safety.
Details the double action thermostat and advises contacting service for issues.
Lists and identifies all components of the unit with numbered references.
Determine drillhole positions, drill holes, and insert wall plugs securely.
Release cover securing screw, open, and remove the cover.
Feed the connection cable seal into the rear wall for proper entry.
Requirements for using a circuit breaker and ensuring proper earthing.
Guides on positioning and sliding the unit onto wall securing screws.
Instructions for making secure electrical connections for N, Earth, and L wires.
Straighten the unit, tighten screws, and connect the electrical supply to the PCB.
Instructions on how to fit the unit's cover and secure it with the screw.
Instructs to turn the rotary control to the 'off' position before proceeding.
Details on how to properly connect the cold water pipe to the unit.
Instructions for fitting the filter and silicone gasket to the unit.
Guides on attaching the shower accessories to the unit.
Outlines regulations to be observed, including isolation distance.
Specifies the recommended installation location and orientation for the shower unit.
Provides detailed technical specifications for the 35 EC and 45 EC models.
Steps to be performed before initial operation, including filling the unit.
Instructions on how to operate, adjust temperature, and safety notes during use.
Guidelines for cleaning the housing and filter, and when to call a technician.
Emphasizes following instructions and avoiding installation in freezing locations.
Warning about damaged supply cords and their replacement by qualified personnel.
Advice on explaining unit function, hazards, and handing over the manual.
Information regarding guarantees and associated terms and conditions.
Company non-liability for failures due to improper installation or unauthorized installers.
Lists causes and rectifications for no hot water, such as flow volume or blockages.
Explains that ELCB activation requires pressing the reset button.
To Next Page
