To Next Page

To Previous Page

f. Install the supplied silicone hose as shown. Orient

the hose clamp screws away from the battery tray as

shown.

g. Attach the rubber mount to the tab near the washer

bottle filler neck using the supplied washer and lock

nut.

h. Install the hump hose to the throttle body as shown.

Cruise control only.

i. Install the supplied grommet in the hole on the upper

pipe. Insert the zip tie into the hole on the upper pipe

bracket (use two zip ties if the car has cruise control).

Questions and Answers:

Need help?

Do you have a question about the AEM Dryflow and is the answer not in the manual?

AEM Dryflow Specifications

General