Need help?Do you have a question about the Aeon Labs Aeotec DSB45-ZWUS and is the answer not in the manual?
General| Product Name | Aeon Labs Aeotec DSB45-ZWUS |
|---|---|
| Category | Accessories |
| Compatibility | Z-Wave |
| Wireless Protocol | Z-Wave |
| Z-Wave Frequency | 908.42 MHz |
| Power Supply | Battery |
| Operating Temperature | 0°C to 40°C |
Remove battery insulator to power on the Water Sensor and prepare for installation.
Position sensor 1 meter high, vertically, within 30 meters of another Z-Wave device.
Ensure probe prongs sit flat on surfaces for water detection or at minimum level for absence detection.
Attach the water probe's mounting plate using waterproof 3M adhesive.
Affix the sensor's mounting plate using screws or double-sided tape to a clean surface.
Follow steps to remove the sensor from your Z-Wave network using a Z-Stick controller.
Follow steps to remove the sensor from your Z-Wave network using a Minimote controller.
To Next Page
