Need help?Do you have a question about the Aeon Labs Aeotec MULTISENSOR 6 and is the answer not in the manual?
Product comes packaged with accessories for installation and operation.
MultiSensor can be powered by battery or USB. Recommends USB for initial setup.
Syncs the MultiSensor with a Z-Wave network using a Z-Stick or Minimote.
Instructions for physically mounting the MultiSensor using its included accessories.
Guides on setting the MultiSensor as a security or non-security device in Z-Wave.
Steps to reset the MultiSensor to its factory default settings.
Instructions on how to wake up a battery-powered MultiSensor for configuration.
Information about the MultiSensor's tamper detection feature.
Details on how the MultiSensor reports motion detection and triggers associated devices.
Procedure to remove the MultiSensor from your Z-Wave network.
General| Product Name | Aeotec Multisensor 6 |
|---|---|
| Manufacturer | Aeon Labs |
| Category | Accessories |
| Battery Life | 2 years |
| Light Sensor Range | 0 to 1000 Lux |
| Motion Sensor | Yes |
| Vibration Sensor | Yes |
| Wireless Technology | Z-Wave Plus |
| Sensors | Temperature, Humidity, Light, Motion, Vibration |
| Motion Detection Range | Up to 5 meters |
| Motion Detection Angle | 120 degrees |
| Z-Wave Plus | Yes |
| Power Supply | USB Power Adapter or Battery |
| Temperature Sensor Range | -10°C to 50°C |
| Humidity Sensor Range | 0 to 100 % |
| Compatibility | Z-Wave certified |
To Next Page
