- -4
4
Advanced Functions
Your Repeater can be removed from your Z-Wave network at any time. You'll
need to use your Z-Wave network's main controller to do this. The following
instructions tell you how to do this using Aeotec's Z-Stick and Minimote
controllers. If you are using other products as your main Z-Wave controller,
please refer to the part of their respective manuals that tells you how
remove devices from your network.
Removing your Repeater from a Z-Wave network
If you’re using a Z-Stick:
If your Z-Stick is plugged into a
gateway or a computer, unplug it.
Take your Z-Stick to your Repeater.
Press the Action Button on your Z-
Stick.
Press the Action Button on your
Repeater.
If your Repeater has been successfully
removed from your network, its light
w i l l b l i n k . I f t h e r e m o v a l w a s
unsuccessful its light will not blink.
Press the Action Button on the Z-Stick
to take it it out of removal mode.
1 .
2 .
3 .
4 .
5 .
6 .
To Next Page
Loading...
General