byte 1 16777216 kVah Clamp 1
byte 1 33554432 kVah Clamp 2
byte 1 67108864 kVah Clamp 3
byte 1 134217728 kVar Clamp 1
byte 1 268435456 kVar Clamp 2
byte 1 536870912 kVar Clamp 3
byte 1 1073741824 Reserved
byte 1 2147483648 Reserved
Additional information on other Gateways uses.
Smartthings Hub.
Smartthings hub does not have any basic compatibility to the Home Energy Meter Gen5, it does not allow you to
access its advanced configuration functions readily. In order to make full use of your Home Energy Meter Gen5 to its
fullest, you must install a custom device handler in order to access other functions of the switch.
You can find the article for the custom device handler here:
https://aeotec.freshdesk.com/solution/articles/6000122372-hem-gen5-2-phase-smartthings-device-handler
(https://aeotec.freshdesk.com/solution/articles/6000122372-hem-gen5-2-phase-smartthings-device-handler)
The article contains the github code, and information used to create the article. If you need help installing the custom
device handler, please contact support about this.
More Advanced Configurations.
You can find more advanced configurations for Home Energy Meter Gen5 in our Engineering Sheet section on our
Freshdesk which can be used to integrate Home Energy Meter Gen5 into a new gateway or software, or use it as a
reference for configurations.
1. Home Energy Meter Gen5 (https://aeotec.freshdesk.com/helpdesk/attachments/6009584689)
To Previous Page
Loading...
Need help?
General
