1. Take your Minimote to your Smart Switch.
2. Press the Remove Button on your Minimote.
3. Press the Action Button on your Smart Switch.
4. If your Smart Switch has been successfully removed from your network, its RGB
LED will remain the colourful gradient status. If the removal was unsuccessful, the
RGB LED will still be solid (Energy mode state when the output is on or Night
light mode state when the output load is off), repeat the instructions from step 2.
5. Press any button on your Minimote to take it out of removal mode.
Advanced functions.
Changing LED mode.
You can change the mode of how the LED acts through configuring Smart Switch.
There are 3 different modes: Energy mode, Momentary indicate mode, and Night
Light mode.
To Next Page
Loading...
