Single tap Controls load state. LED Follows load control state.
Press 2 times within
3 second. (Not
paired to a Z-Wave
network)
Enter pair/inclusion mode.
Blue fast blink, after first Click Red
and after second Click Orange.
The LED changes to a green color if
the device paired successfully.
Press 2 times within
1 second. (Paired to
a Z-Wave network)
Enters unpair/exclusion mode
After press 2 times the led indicate
purple.
After inclusion, the LED flashes
Blue
Press 3 times within
2 seconds.
Disable alarm response when
the alarm is activated.
LED flash stops.
Press and hold for 2
to 5 seconds.
Toggles LED display mode
when SS7 is paired.
Yellow LED
Enabled - LED follows
ON/OFF state.
Disabled - LED is disabled
Press and hold for 5
to 10 seconds.
Test communication quality
Indicator Light will become cyan
light when press, and quickly flash
cyan light when release, indicating
start to test communication quality
between the product and Node 1.
At the end of the test, Indicator
Light will display the colour
according to the communication
quality.
Great = green light for 2s.
Good = yellow light for 2s.
Bad = red light for 2s.
Press and hold for
10 to 15 seconds.
Reset overload alarm and
overcurrent Alarm
Red LED flashes
Press and hold for
15 to 20 seconds.
Stay in Z-Wave network, but
factory resets all settings back
to default.
Red LED Flashes faster.
Press and hold for
20 seconds and
more.
Completely factory reset and
remove from Z-Wave network.
Fades blue LED in and out slowly
Important safety information.
Please read this and other device guides carefully. Failure to follow the recommendations set forth by Aeotec Limited may be
dangerous or cause a violation of the law. The manufacturer, importer, distributor, and/or reseller will not be held responsible
for any loss or damage resulting from not following any instructions in this guide or in other materials.
Keep product away from open flames and extreme heat. Avoid direct sunlight or heat exposure.
To Next Page
Loading...
Need help?
General
