MultiSensor
Manual
Unlock the MultiSensor from its battery cover by twisting the
battery cover from the main unit in a counter-clockwise
motion and pulling the battery cover outward to separate the
main unit from the battery cover.
The following instructions have been designed to help you
install and get the best performance out of Aeotec’s Z-Wave
MultiSensor.
Powering The
MultiSensor.
The Aeotec MultiSensor has built-in battery level detection. It
will automatically report its battery level to the associated Z-
Wave gateway throughout its life until the battery is fully
drained and needs replacing. Most gateway user interfaces
will inform you of the battery status.
When used properly in an optimized Z-Wave network,
operation via battery can function for 12 months before
battery replacement.
To Next Page
Need help?
General
