Advanced.
Drivers for Zi-Stick.
Typically you do not need to install drivers, most operating systems will have the drivers necessary to run the Zi-Stick.
But in some cases these drivers may not be installed on some OS systems, you can find the serial bridge drivers here:
• https://www.silabs.com/developers/usb-to-uart-bridge-vcp-drivers (https://www.silabs.com/developers/usb-to-uart-
bridge-vcp-drivers) (https://www.silabs.com/developers/usb-to-uart-bridge-vcp-drivers) (https://www.silabs.com/developers
/usb-to-uart-bridge-vcp-drivers)
Current compatible software and setup guides.
Zi-Stick will be used with your software of choice. Below is a list of all the known software that is compatible with Zi-
Stick and how to set them up.
• (https://help.aeotec.com/a/solutions/articles/6000246295) (https://aeotec.freshdesk.com/a/solutions/articles
/6000246295)Setup Zi-Stick with Home Assistant (https://aeotec.freshdesk.com/a/solutions/articles/6000261821)
• Setup Zi-Stick with OpenHAB (https://aeotec.freshdesk.com/a/solutions/articles/6000261822)
To Next Page
Loading...
