AerialBox t2100 - Manual Timer

35
Manual Timer
How to set up the Manual Timer
1. Set the Timer Mode to Once, Daily
or Weekly to make a recording. If this
option is set to Off, the timer will not
operate.
2. Set the Wakeup Mode to Recording,
Services or Message. If you only want
the unit to wake up on a channel at the
set time without recording, set this to
Services
3. Set the channel you want to record,
or set the message you want to appear
at the set day and time.
4. Set the Date option to a desired
date, on which the digital receiver will
turn on. Use the left, right buttons on
your remote to navigate and change.
The date format is Day/Month/Year.
5. Set the start Time option to a desired
time, at which the recording will be
started. Use the left, right and number
buttons on your remote to navigate
and change. The time format is
Hour:Minute.
6. Set the Duration option to a desired
length of time, in which the recording
will be nished. Use the left, right and
number buttons on your remote to
navigate and change.
You can set a service to be recorded at a specic time. Even if the digital receiver
is in standby mode, it will start recording at a specied time.
When the recording comes to the end the unit will stay awake until you press the
standby button. A maximum of 8 timers can be set at once.