Getting started – how to assemble?
Step 1 – lift the hose covers on the sides of the boots and connect
one by one the pins of the air hoses to the boots
Step 2 – make sure the pins are air-tight and connected securely,
then close the hose covers
Step 3 – click-connect the hoses of each boot to the Quick
connector. Make sure the “arrows” on the connector are facing
upwards
Step 4 – click-connect the Quick connector to the Aerify Charge
machine and you are ready to go!
+
Step 1
Step 2
+
Step 3
Step 4
To Next Page
Loading...