15
STARTING
1. Plug into the socket of the electrical system (the electrical power supply is single phase 230V at , the plug provided
is a Schuko 10/16A with double ground contact, according to the EEC standards (VII).
2.Rotate the humidistat, choosing this way the most ideal position according to the percentage of humidity to
be extracted (see following paragraph).
3.Position the function selector at the desired speed.
humidistat
The humidistat measures the air humidity and activates or deactivates the compressor, according to the level
that has been selected with the rotary control: The lower the level selected the higher the percentage of humi-
dity eliminated from the air The scale of the rotary control starts with OFF position (dehumidifier switched off),
and finishes with CNT position (dehumidifier operating continuously).The scale of the rotary control give an
approximate indication on the percentage of humidity which must be obtained in the room.Ex.if the switch in
the middle between OFF and CNT it means that we have a 50% of relative humidity, suggested for domestic
rooms.
In order to adjust the humidistat at the optimal level it is advisable to begin by adjusting it on position (CNT) so
that the machine eliminates the excess of humidity in the environment.
When the humidity is at the level required slowly rotate the command of the humidistat anticlockwise until the
apparatus turns off.
From this moment the dehumidifier will be regulated to your comfort level and the humidistat will keep it
automatically.
It is advisable to set the degree of humidity in the humidistat when the seasons change or according to the
weather conditions.
FUNCTION SELECTOR
This makes it possible to select the speed of ventilation required and, in the models with electrical heater (DF R)
, to activate the heating .
DF R
WORKING
DF Version
The dehumidifier can carry out the following opera-
tions:
1.dehumidification: the degree of humidity required is
selected.
2.fan: the required ventilation speed is chosen.
DF R version (models with heating element)
The dehumidifier can carry out the following opera-
tions:
1.dehumidification: the degree of humidity required is
selected.
2.fan: the required ventilation speed is chosen.
3. heating: the humidistat stays in the OFF position
and the function selector must be positioned on .
DF
To Next Page
Loading...
Need help?
General
