AERMEC VMF E6 - Dhw Timed Program Setting; Alarm Log Menu; View Alarm Log

0123 4 5 6 7 8 9 10 11
12 13 14 15 16 17 18 19 20 21 22 23
no. 1
:
:
:
:
TIMED PROGRAM Mon
ALARM LOG
Alarm
Date
Time
Origin
Type
A
B
A
B
C
D
E
21
Ital
i
an
o
EnglishFrança
i
s
D
eutsc
h
E
spaño
l
DHW timed program setting
In the DHW timed program setting window, you can make the following set-
tings:
A
The status to be assigned to each hour of the day: the DHW timed
program is weekly, which means it can be set by specifying a different profile
for each day of the week (check the label at the top right of the screen
B
to
see which day of the week you are setting). Each daily program is sub-divided
into 24 bands (one for every hour) in which you can define the required DHW
status by clicking on the key for the relative hour. Every time you press the
same key, you will move on to the next status. The cycle follows this order:
DHW
DISABLED
DHW
ENABLED
Anti-legionella
cycle (*)
(*) the anti-legionella cycle can be enabled no more than once for each
day of the week, but remember that it MUST BE ENABLED to prevent
any possible health risks.
By pressing the key on the lower part of the screen, you can copy the time set-
tings of the current day in ALL the days of the week (a drop-down window will appear,
asking for confirmation of the operation).
To select a different day of the week, press the key on the lower part of the
screen.
To return to the previous page, press the key. The homepage will be restored au-
tomatically if 5 minutes elapse with no interventions.
ALARM LOG MENU
View alarm log
In the alarm log menu, you can see the last 20 alarms recorded on the system.
Each alarm is identified by certain information:
A
Alarm indicator: a number (from 1 to 20) that identifies the alarm
B
Date: the date when the alarm was triggered
C
Time: the time when the alarm was triggered
D
Origin: the component that triggered the alarm
E
Type: description of the alarm
The keys along the bottom of the window allow you to:
Navigate the various alarms recorded: to select a different alarm, press the
(next) and (previous) keys.
Reset the alarm log: to completely reset the alarm log, press (the oper-
ation must then be confirmed in a drop-down window).
To return to the previous page, press the key. The homepage will be re-
stored automatically if 5 minutes elapse with no interventions.