Subject to Export Control, see Cover Page for details. 2-91
2-5. OPERATING PROCEDURES
Operating Procedures for the 3500 / 3500A are provided.
Refer to para 2-1 for further description of the controls, indicators and connectors.
Refer to para 2-2 for further description of the operation screens and menus.
2-5-1. INTRODUCTION
The 3500 / 3500A is intended to be used to determine that all external connections are in place on
the vehicle radio installation and that the antenna is connected and matched to the transmitter.
When the 3500 / 3500A is used in conjunction with the BIT built into the UUT, the user is able to
establish, with a 95% probability rate, that the installation is operational. If the UUT is not
operational, the user can determine where the fault lies to such a level as to recommend corrective
action (i.e., replace the antenna, return the radio for repair etc.).
To Next Page
Loading...
