14 Aeroneb
®
Professional Nebulizer System Instruction Manual
5. Connect the control module and the nebulizer unit
together using the control module cable (Figure 4).
Figure 4: Connecting control module and nebulizer unit
6. To operate on AC power (the primary mode of operation),
insert the AC/DC adapter connector into the control
module and plug the adapter into an AC power source
(Figure 5).
7. Aeroneb Pro can be battery-operated for portable
applications. The rechargeable battery can power the
System for up to 45 minutes when fully charged. In the
case of AC power failure the control module will
automatically switch to battery operation.
Note: Allow a minimum of four hours for the internal battery to
fully recharge.
Note: To ensure uninterrupted operation of Aeroneb Pro,
secure both the AC/DC adapter cable and the control module
cable so they cannot become disconnected during treatment.
If clips are available on patient circuits, run the cables through
the eyes of the clips. If clips are not available, ensure that all
cables are routed safely.
To Next Page
Loading...